FD engine into FC
 

I want to put in an FD engine into my 87 FC. I'm clueless.
Is there any problems on swapping it in because I'm confused
:Wconfused :confused:



so if you can help me out plz

Look through the writeups in this section as it's been covered a number of times. Up top on the page you should see a section with FAQ like this one.

On another note...why are you wanting to swap these motors instead of just putting the money into your engine now? Is your car a turbo (I doubt that because you're asking this) and if it's N/A why not just put the turbo drivetrain into the car if you HAVE to have a turbo swap (or just use the money and try to find a turbo car).

I'm not bashing you at all, I'm just wondering your line of thinking and giving you some more cost effectvive ideas...are you new to the rotary world btw? It's an expensive place to be so keep that in mind :)

K

i am going to tell you the search on this site should be your friend, this has been covered so many times, and is not a good idea, and be prepaired to get flamed,

http://fc3spro.com/TECH/SWAP/FD3S/rew.html

ill repeat this like everyone else..."why not go with a 13bre?"

Cosmo.

Renesis.

13B N/A.

Lol.

+ = Don't do it. You are nowhere near at the skill level this project requires.

I'm not trying to be offensive, just saving you some time. Do a bunch more searching on this forum to figure out whats involved. Buying/welding brackets, ECU questions, etc. Its entirely possible, but research first. This information exists.

1. search
2. there is a guy who has made mounts
3. if yo udont know what you are doing pay someone to do it
4. why do you want the fd motor anyway

Thread closed... covered in the FAQ fir FC sticky thread. Please read the FAQ for FC sticky thread found at the top of this the 2nd gen RX-7 technical section, before posting. Many commonly asked questions (such as the one this thread was started with) are covered there