RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   2nd Generation Specific (1986-1992) (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/)
-   -   Exhaust leak (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/exhaust-leak-312666/)

MAX-IMAL 06-01-04 10:57 PM

Exhaust leak
 
On a S4 would an exhaust leak cause the 5th and 6th port not open properly??? and what other symptons besides bad mpg??

Thanks

SonicRaT 06-01-04 11:37 PM

Where's the leak located at?

J-Rat 06-02-04 12:13 AM

It could cause the ports not to open.

SOIA 06-02-04 01:15 AM

:werd: or cause them to open later

Adam 06-02-04 01:22 AM

I had a exaust leak from where the pipe go's into the cat! J B weld Solved that problem..cheap fix if you dont have the tools to weld the hole shut!

gildardo 06-02-04 02:52 AM

so is J B weld strong. has it wistood the high heat.

Kenteth 06-02-04 04:09 AM

JB weld is going to hold up to that much heat?

MAX-IMAL 06-02-04 09:54 AM

The exhaust leak is located between the block and the header I have a fuged up stud that I never taked care so that side of the header it was with out a bolt and loose , I made a thread on that, long story short I took a look at the gasket and all the upper right corner was all burned up , I'm just asking what would be the symptons in that case: besides low response and powah. Right now I'm still working on my tranny swap and i'm working also on problems like that stud while I have the car on jacks .

thank you


All times are GMT -5. The time now is 09:17 AM.


© 2024 MH Sub I, LLC dba Internet Brands