Custom Driveshaft, where can I find a aftermarket Yoke?
 

I need a TII Yoke, or a yoke from another vehicle that will fit a TII transmission.

I know that a certain dodge yoke is the same size as a FD yoke. But, I'm not sure about the TII.

Let me know.

Anyone?

Driveshaft shop. Or post up in the FS/WTB section.

You should be able to take some measurements and find one. Check a driveshaft shop, they will know what to measure and tell you if they can get one.

What are you trying to do exactly?

If your trying to have a n/a transmission go to a T2 diff its very easy to mod the na driveshaft.

PM me if you want the awnser on this. - Nick

or if you wanna go TII trans to n/a rear it is a easy mod too.

Maybe you could contact Mazdatrix. They don't have the yoke listed, but wouldn't it have to be part of their custom driveshafts w/ replaceable u-joints?

http://www.mazdatrix.com/g9.htm

Yeah super easy! Put in a driveshaft from any automatic FC!

or you could dremel the holes just a little bit and it will fit 100% and you dont have to worry about the automatic shaft being shorter. I just did this

I think we have a winnign solution..lets hopw this is his plan...LOL...I should have thought of that! I drove on a auto shaft for a long while with no problem before the LSD swap!

I actually got the idea from a thread hypertek posted on here. I actually seached and found it lol. I have much more confidence on the actual TII shaft than one for an auto. But still to each his own. I cant wait to get my lsd after i get my top and some other stuff on my never ending list of parts

Like I said, I drove on the auto driveshaft for a long time with a NA rerar end with no problems...but once you go to LSD you need a real Turbo II driveshaft. 4:10 gears make all the difference.

no i think he wants a t2 yoke for a custom drive shaft for a t2 tranny in a first gen rx7

I got the front half of a TII driveshaft.With U joint.