Check out this injectors!
 

http://cgi.ebay.com/ebaymotors/ws/eB...tem=2454117004

Anyone know if this injectors fit 2nd gen TII rail/manifold?.. Im thinking of picking 2 pairs of 750cc for my future SAFC+hybrid turbo setup.. I have an 87TII.Thanks in advance!!..FCTURBO2

bump

they should fit the rail, they appear to be the standard Bosch style/

"MSD" injector are "Rochester" type, and are not like the Bosch/ND top-feed injectors.  They could possibly fit, but I doubt it - they are typically a little shorter than the ND top-feeds.


-Ted

The bottom, above where the pintle is (Where the lower grommet will sit) looks different...

i have eight of those gm pn#17087960 not sure of lbs but i need to find out.

Thanks Ted...You da man.

Holley injectors are good. I have some 75lb ones in my Starion and am very happy with them. They are also the bosch style but impedence varies by size. 50lb/hr. and below are high imp. 55lb/hr and up are low. Just so youll know if you find some and they dont say.

i use 4 1000cc (96lb) rochestor/msd injetors in my rotor. they are top feed and work great. however you will need s4 (pre 89) cast alloy fuel rails as they need to be drilled out to 16mm. use the standard flat faced rubber o-rings for the outlet and o-rings proivided with injectors for the inlet. very easy to do

I'm running the same style injectors for the secondaries. I drilled out the rail to make them fit.

50lb/hr injectors are smaller than stock on a TII. No one would use them.