Cheapest place to pick up LSD and 4.33 ring/pinion set
Just like the title says. I'm looking for a place to pick up an aftermarket diff like a 1.5 way Kaaz unit and a 4.3 ring and pinion set.
I have an 88 T2 and I have broken 2 diffs and I'm trying to build something that will last alot longer. |
The cheapest I've seen so far is.
Drift Factory has them for $786.25 Part number SBZ1310 Kaaz 1.5 way And the Ring/Pinion from RX7.com for $449 |
What broke? I thought the S4 TII diff was supposed to be very strong. You might have some luck searching the classifieds for the gear, but it's not that likely.
|
The first diff started to act like an open diff. Sometimes if you turned one wheel the other would turn the opposite direction. When I swapped the fluid I found clutch pack pieces.
The second diff blew when I was launching at the track and I heard a pop then it fell on its face. I suspect the spider gears in this one or maybe a couple of clutch packs breaking. When I turn the driveshaft by hand and the rear lifted I can see the passenger tire barely catching. When I spin a tire it spins with the other tire just sitting there or you can see it barely twitch. I'll find out when I swap a new diff in when really broke. I want to put in a brand new aftermarket unit and I haven't heard of anybody breaking any Kaaz LSD's. Used diffs are just going to do the same and break or are already worn out. |
You can rebuild the differentials, Mazdatrix sells the parts
|
Its almost $600 for the clutch's if I'm reading the parts right. Is it really worth it to rebuild the stocker?
|
if the ring and pinion arent broken or very well worn (as if they were mal-adjusted earlier in life), you should be able to use them over.
|
The ring and pinion should be good in my original diff housing, but I want to try out the 4.3. I know it isn't much more different than the stocker 4.1. I read somewhere its like a %5 difference or even 2 tenths of a second down the 1320. I'm still trying to read more into it.
|
well you can do what the 1st gen guys do and swap in a ford and iirc some kia rear ends where used. theres a ton of info in their section (im also an SA owner :) )
|
Originally Posted by 95nracer
(Post 7391441)
Its almost $600 for the clutch's if I'm reading the parts right. Is it really worth it to rebuild the stocker?
|
ebayyyyyyyyyy
|
Originally Posted by dean23
(Post 7391553)
well you can do what the 1st gen guys do and swap in a ford and iirc some kia rear ends where used. theres a ton of info in their section (im also an SA owner :) )
Not even the same kind. |
All times are GMT -5. The time now is 01:34 AM. |
© 2024 MH Sub I, LLC dba Internet Brands