Car fails to run beyond startup after filter change.
1988 RX7 that sat a few weeks as we were getting the trans out due to an issue with the car being stuck in one gear and found the pilot bearing came apart. That replaced and the trans about to go back in, we thought it a great time to replace the fuel filter as she sits right next to the bellhousing on the drivers side. One she was buttoned up and everything put back together. My nephew then went to start her a day later and she'll fire up but then die, even though he knows well the starting procedure. No bleeder on the fuel rail, so he tested the fuel pressure right after the filter and got 35-40 psi, but after the initial start, it drops to 5 psi. I'm thinking air in the line, and we tried to bleed it best we can as this design is what it is.
Any ideas? |
Should check if the pump is working when cranking the car.
|
Originally Posted by DR_Knight
(Post 12594701)
Should check if the pump is working when cranking the car.
|
Dealing with fueling issues on my BMW and there was a problem where the DME would send the fuel signal to the fuel pump during cranking, but then wouldnt tell the pump that the car was actually RUNNING, and as soon as it lit the fuel pump would shut off. Not sure if theres any similarity. May be worth seeing if you lose power to the fuel pump once the car lights and you stop cranking.
|
welcome to the board. :)
do you have a copy of your FSM? if not, you can get one here: Foxed.ca you can use it to try troubleshooting the fuel pump circuit while you wait for answers from other members. my first guess would be take a look at the relay. |
Originally Posted by diabolical1
(Post 12594774)
welcome to the board. :)
do you have a copy of your FSM? if not, you can get one here: Foxed.ca you can use it to try troubleshooting the fuel pump circuit while you wait for answers from other members. my first guess would be take a look at the relay. |
Originally Posted by lespaul166
(Post 12594718)
Dealing with fueling issues on my BMW and there was a problem where the DME would send the fuel signal to the fuel pump during cranking, but then wouldnt tell the pump that the car was actually RUNNING, and as soon as it lit the fuel pump would shut off. Not sure if there's any similarity. May be worth seeing if you lose power to the fuel pump once the car lights and you stop cranking.
We'll see. At this point, all troubleshooting ideas are good ideas. Thanks! |
Is the air flow meter plugged in? There's a switch inside it that tells the circuit-opening relay under the dash that the engine is running and powers the fuel pump. This relay has a second input (from the ignition switch) so it runs the pump while cranking as well.
If the air flow meter is unplugged (or faulty (unlikely)) it will cause what you're describing. The ignition switch will still power the relay while cranking, but once you release it to the on position the relay loses power. The other option I can think of is that the fuel pump is going bad and can't sustain pressure. Maybe it's fine when cranking since the engine uses very little fuel at <250 rpm, but once the car starts up it drains the rail faster than the pump can maintain pressure. That one's hard to diagnose other than just swapping out the pump |
Originally Posted by WondrousBread
(Post 12594838)
If the air flow meter is unplugged (or faulty (unlikely)) it will cause what you're describing. The ignition switch will still power the relay while cranking, but once you release it to the on position the relay loses power.
|
Originally Posted by WondrousBread
(Post 12594838)
Is the air flow meter plugged in? There's a switch inside it that tells the circuit-opening relay under the dash that the engine is running and powers the fuel pump. This relay has a second input (from the ignition switch) so it runs the pump while cranking as well.
If the air flow meter is unplugged (or faulty (unlikely)) it will cause what you're describing. The ignition switch will still power the relay while cranking, but once you release it to the on position the relay loses power. With the key on, you can push the flapper door open and listen for the fuel pump turning on. |
All times are GMT -5. The time now is 12:36 PM. |
© 2024 MH Sub I, LLC dba Internet Brands