RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   2nd Generation Specific (1986-1992) (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/)
-   -   Bogging at 4k+ RPM's (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/bogging-4k-rpms-653116/)

Boosted11 05-16-07 10:45 PM

Bogging at 4k+ RPM's
 
So i was driving my car home from work and the car drove perfectly. Later on that night i went out and when i hit up to 4k+ rpm's the car would just start bogging and i would have no power at all.

About a half hour later I drove my car again and it was back to normal. Whats wrong here? Could it be fuel air ratio?

Boosted11 05-17-07 12:22 AM

Hello

TehMonkay 05-17-07 12:48 AM

Something to do with the 3800 rpms hesitation, is your fuel filter clogged?

matt566 05-17-07 12:53 AM

secondary injector come online at 3800
meter your secondary injectors at ecu
they should be at 12v then drop to like 7
it could be your injectors or ecu
if it goes to 12 then 7 then back to 12
its probably ecu
thats what happend to me

Boosted11 05-17-07 01:47 PM


Originally Posted by TehMonkay (Post 6949050)
Something to do with the 3800 rpms hesitation, is your fuel filter clogged?

It very well could be. I havent changed it ever but could of been replaced before i bought the car, and ive had it for about 5 months now.

Oh, and another problem i have is my oil pressure gauge doesnt work anymore, im assuming its the gauge itself or some type of censor but dont know where the censor is located.

apexFD 05-17-07 02:04 PM

Is your car turbo??? if so you might have a big vac leak. If not then you should redo all your factory grounds, if that doesnt work seafoam it.

Boosted11 05-17-07 02:27 PM


Originally Posted by apexFD (Post 6950707)
Is your car turbo??? if so you might have a big vac leak. If not then you should redo all your factory grounds, if that doesnt work seafoam it.

Car is a 1986 s4 n/a.

And you know what im glad you said that about factory grounds because when i swapped out my factory battery cables for new ones i remember half assing the ground to the left side of the body just till i have a connection piece. So at the moment all the pieces of wire are grouped up and clamped down with a screw to the body. Haha im an idiot. Ill get a connection piece today and see if that helps.

FelixIsGod29X 05-17-07 02:29 PM

Check/clean your secondary injector connections, it always fixed the 3800 hesitation for me and a few others.

NoDOHC 05-21-07 10:13 PM

The stock oil pressure sender is on the rear housing right below the oil filter, I have had the wire get pulled off by my shirt sleeve when I was changing spark plugs.


All times are GMT -5. The time now is 11:11 PM.


© 2024 MH Sub I, LLC dba Internet Brands