bleeding clutch continously ????wtf
i put a new clutch in my 88 n/a and i bled the clutch and it would go into gear then itll stop goin into gear and ill bleed it some more and get more air out and itll do the same thing over and over like there is air steady going into the system somewhere
|
make sure all joints are tight and that you NEVER let the reservoir run dry while you're bleeding it. those would be the first steps.
also, it's possible to let air into a bleeder kit right at the valve you're bleeding to. if you unscrew it too loose then when you release the line pressure it can suck air through the threads into your line and your bleeder line. I've had this happen before, but only when bleeding systems on my own because then I had to use a bleeder kit and leave the valve somewhat open while letting off the pressure. I'd recommend having someone man the pedal if you haven't yet, it may help. some bleeder valves are just not very good, I found on my 323 that one or two of my brake bleeder valves would do that. they'd seal fine when tight, but there was no in between from on or off, just a couple degrees open and it'd let air into the system. quite aggravating when you don't have friends to help out. |
make sure the bleeder is tight but not two tight it would suck to strip that bleeder or brake it off in there
|
Replace the master and slave cylinder.
Also, at the same store please purchase some punctuation and sentence structure. :) |
lol run on sentance man. but ive tried the master and slave cylinder both off of my parts car and its unlikely that the one of my car and the parts car are bad
|
It can be quite likely. If those parts sit for a few years (or even months in some cases) they develop rust pits in the cylinder bore.
The problem may also be pinhole cracks in the rubber clutch line. |
Originally Posted by Aaron Cake
(Post 7382726)
The problem may also be pinhole cracks in the rubber clutch line. |
thanks guys hopefully this info will get her back on the streets
|
I had a bad clutch hose, but it didn't let air in, just fluid out.
|
All times are GMT -5. The time now is 11:56 AM. |
© 2024 MH Sub I, LLC dba Internet Brands