Aftermarket TII Manifold? Where??
 

Ok, i am looking into picking up this tII. I have a 60-1 laying around that was on my honda- However, its exhaust wheel (.63) is apparently too small for the tII, i am going to trade it or upgrade the wheel to a larger stg 5. wheel.

Now with that said, what after market manifolds do you guys run?

Also, what kind of power will the fc support on the stock fuel system, running say a S-afc? I figured i could get about 10psi from the 60 on the stock fc? I am new to FC's though, not turbo....just FC's and turbo.

www.rx7store.net has some aftermarket manifolds with T04 flanges. I have seen in person an 89 TII put down 320rwhp with the stock fuel system, but that was not with an S-AFC, it was with a full standalone unit. The mods were upgraded compressor wheel on stock turbo, cone intake, and exhaust. It still had the stock intercooler and stock ports. The injectors were very near full duty cycle at that hp level.

anywhere else?

320rwhp with stock injectors??

I would say safely 250 on stock fuel system! that means injectors, FPR, and Pump! any more than that I would start with a new Fuel pump then injectors and then FPR with s-afc you could do 320 RWHP... but will require good tunning!