Aftermarket Fuel Rail Options
 

What is there for aftermarket fuel rails for the FC? I would like to run the primary and secondary rails in parallel.

Check out www.kgparts.com I am running them on my build!

http://www.fc3spro.com/TECH/MODS/FUEL/frails.htm

http://www.fc3spro.com/TECH/MODS/FUEL/fpr.htm

http://www.fc3spro.com/TECH/MODS/FUEL/pararail.jpg

All the info you need, and more, you can find at FC3S Pro.

I can not use the stock fuel rail with the fuel system I have. I am running -08 lines and do not have the room for adapting to the stock 5/16" line. I am also uncomfortable with welding on to the stock fuel rails.

Do you have a picture of the fuel rails?

hey guys had the same question so i didnt want to make a new thread. Couldnt find much of a different option. I used to see one on Ebay awhile back for pretty cheap but it may have been for the fd motor, and i cnt find it anymore. Anybody find a different option thanks guys..
brian

why are you running -8 lines to the rails? usually a -8 feed line to 2 -6 lines tothe rails is eneough.

-6 lines will support 600HP.

-8 is very large. Are you building 1000 HP 13B? :)

Welding AN flares onto the stock rails is going to be the most compact installation you can create. If you can't weld, then braze them on. Just cut the ends of the rails and go for it...Worst case is that you ruin $20 worth of parts.

I thought brazing is a form of welding...

UPDATE: I got the KG PARTS rails and used -8 lines.

Why go so big? I wanted a factor of saftey of around 2 for the fuel system.

Oh, and FC3S91, I would have definately bought these had I seen them before I got my other rails. These pieces look spectacular!!

Brazing is much like soldering, but done at a higher temperature with a different filler material. In most cases it's as strong as a weld.

Thanks, Mr. Encyclopedia!! :o)