yeah, i know of all the O-rings and grommets i need to replace. diggin the new avatar BTW.
anybody happen to have a fuel pressure guage i could borrow so i can test fuel line pressure while i'm at it? |
Thanks, Ray didnt like my old one
avatar nazi :D |
*thread-jacked* :D
<font size="-2"><b>aiight, mattie, i'ma be out there monday. hopefully i'll be bringing a hub with new bearings to be installed, a few ground cables, you'll have that tps.. am i forgetting anything? i do that. plus, i'd like to find out why my stereo died. no power is going to it. electrical is fun. like scratching month old scabs. </font></b> |
Sweetness
Ill PM you my address so you can do a map quest, Ill also give you a call tonight since your gay ass probably wont see this. |
<b>my gay ass didnt see that, but my straight virgin ass sees it clearly. i will impail</b> <font size="-2">(sp? not in dictionary)</font><b> you with a big stick.</b>
|
*ahem* what was this topic about again... is that hesitation gone.. I sure hope so...
:) |
well fellers, today i installed another cat so i could actually run my car at night without the neighbors being upset at the noise. when i went to start my car afterwards it started up great, had an awesome idle and there was almost no hesitation.
i fine tuned the setting of my TPS and the hesitation was gone!! i drove my car today as if nothing was ever wrong with it. from about 2pm to around 10pm i drove my car and enjoyed all the fun an FC has to offer. however, once it got close to around 10 .......BAM......hesitation returned and i am now right back where i started with random hesitation and sputtering/backfiring on deceleration then dying. it will always start right back up but goes right back into being kinda unstable. today was the longest i have been able to run it without a problem since it all started a couple months ago. what a fun day, but i just don't know.:( |
i went to autozone and bought 5 ground (battery) wires. a 40", 2 19" and 2 24".
|
"just pull the injecters" they say.
Bah!! what a load of crap. injectors are a big ass pain to get to. well, i finally got em out and it looks like i'll be replacing a bunch of vac. lines i broke. the o-rings aren't terrible but they are not a "tight" seal. the thick grommets were hard as rocks, the outside of the injectors were black and had crud on them(especially the primaries), the pintle caps are extremely discolored and have some buildup on em(at least on the outside). any recommendations for cleaning em on my own? or should i buck up and have em pro cleaned? suggestions for local injection cleaning? |
how did this end up in the "other rotary" section? moving to 2nd gen section. hope thats right. :wavey:
|
All times are GMT -5. The time now is 04:12 AM. |
© 2024 MH Sub I, LLC dba Internet Brands