1988 Fc Vert Help
 

Whatsupp RX7C, I am currently building a n/a 1988 FC vert with minor mods such as cold air intake, RB Exhaust system, Dual alternator pulley kit, New plugs, wires, Etc.

I had a couple questions that I am stuck on. I am also a newbie that has been bitten by the rotary bug and fell in love with them. :crackup:

* What is a good oil catch can and its corresponding locations to be hooked up at?

* With my OMP system removed, What is the best brand of premix to use? I have done some research and have come across the ratio of 1 oz of premix per gallon of fuel. Is this correct?

* When I purchased the car the injector wiring clips were all destroyed. Would I be able to cut back a few inches and crimp new injector wiring into the harness ?
Is there a difference in the injector wiring ?
What is the best place to purchase new injector wiring ?

Once again I am new to rotaries, however any information will be greatly appreciated. Many Thanks !!!!!!!:worship:

if the problem is just the plastic. you can buy a new pigtail, de-pin that and just change the plastic part. it works great and no actual wiring needed

Thanks for the info, It is just the plastic, I will post a pic of how it looks.
https://cimg2.ibsrv.net/gimg/www.rx7...ba1b55fb2d.jpg
https://cimg9.ibsrv.net/gimg/www.rx7...b76cc361d8.jpg

yeah just buy a new pig tail, pull the wires out, and swap plastic, done. no wiring needed

I premix based on this article, however my car is just stock and I want the most miles out of it.
https://rotaryperformance.com/blogs/...-not-to-premix
It's easy to buy the weed eater stuff but it will make your car smoke quite a bit when cold and will smell like a weed eater :D