Slave cylinder mounting for Manual 5 speed to 20b
#1
Junior Member
Thread Starter
Join Date: Nov 2017
Location: Washington
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
Slave cylinder mounting for Manual 5 speed to 20b
How do you setup a clutch slave cylinder up to a 20b since they are all automatic when you switch over to a 5 speed and the rear iron does not have a provision to mount it as in the 13B-REW rear iron, looking at a repu with a 13B-REW engine currently installed. Also thought about a T5 conversion also so as to maybe avoid cutting a new hole in the cab.
Any help would be appreciated, just trying to get answers before I go down the 20b road with a repu.
Any help would be appreciated, just trying to get answers before I go down the 20b road with a repu.
#2
Spankin' the Wank
iTrader: (21)
How do you setup a clutch slave cylinder up to a 20b since they are all automatic when you switch over to a 5 speed and the rear iron does not have a provision to mount it as in the 13B-REW rear iron, looking at a repu with a 13B-REW engine currently installed. Also thought about a T5 conversion also so as to maybe avoid cutting a new hole in the cab.
Any help would be appreciated, just trying to get answers before I go down the 20b road with a repu.
Any help would be appreciated, just trying to get answers before I go down the 20b road with a repu.
Matt
Last edited by highnitro12187; 12-02-17 at 09:02 AM.
#3
Junior Member
Thread Starter
Join Date: Nov 2017
Location: Washington
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the input on where the later slave cylinder resides, I owned a Turbo II back in the early 90's but was not aware that the slave cylinder was mounted on the transmission. On the early RX3 RX4 Repu it was mounted on the rear housing.