20b factory motor mount Hardware/uim/lim hardware?
 

The block I have purchased has quite a few rusty exterior items. I'm also missing various hardware pieces.

I'm primarily looking for factory motor mount bolts/studs/washers. Does anyone know the replacement specs or where to find these fasteners?

I'm secondarily looking for UIM/LIM bolts/capped nuts that attach the manifolds to the motor. I assume the 13b-rew bolts will work, I'll just need more of them.

Thank you!

nuts and bolts are just that...nuts and bolts, go to your local shop and pick the right diameter and thread pitch = job done (just watch the tensile strength)

as for the rubber mounts, Mazda should still do them, failing that if you want a semi-solid setup get some urethane spun up instead. (will increase vibration through your car)

:icon_tup: Good info. Ill just clean the threads and measure the pitch/diameter. Definitely going to look into having urethane spun. I don't mind vibrations from these motors. Ran delrin on the last setup.

Pm me I just got my 20b and I will not be using the stock mounts and I might not be using the hardware