RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   1st Generation Specific (1979-1985) (https://www.rx7club.com/1st-generation-specific-1979-1985-18/)
-   -   White Sludge (https://www.rx7club.com/1st-generation-specific-1979-1985-18/white-sludge-151869/)

willhogan 01-23-03 11:04 PM

White Sludge
 
I had a fresh rebuild done three weeks ago and I have just gone through the break in period. Upon changing the oil I notice white sludge near the filler and the dip stick. Is this normal with a new motor.

RotorMotorDriver 01-23-03 11:18 PM

Do you have a breather on the filler neck? Are the emissions still intact?

~T.J.

willhogan 01-24-03 12:14 AM

nevermind. Than god, I just did an oil change it must have been water that condensated into my oil cooler when the car was sitting. Just a little bit of clums around the dip stick and filler nothing clumpy in the oil.

willhogan 01-24-03 12:15 AM

no emissions and yes I have a breather

680RWHP12A 01-24-03 01:06 AM

dont worry , its proabably cold where you are , its common in cold climate to build condensation in the motor ....,, especially under the oil cap and at the top of the dipstick!! its good to be aware though!

inittab 01-24-03 06:15 AM

a few nice looong drives will dry it out. Guys that only take their cars on short trips have this problem.

jeremy 01-24-03 08:43 AM

changed my oil last night and had the same thing.

Pele 01-24-03 09:13 AM

Paint the inside of your filler tube, or better yet, get it powder coated.

specRX7_22 01-24-03 05:05 PM

if you often start up your car and shut it off before the engine temp get up to normal, this is common. i dont think its a problem tho.

MIKE-P-28 01-24-03 09:07 PM

everyone's does this, search the forum I gave an explanation as to why :)


All times are GMT -5. The time now is 02:31 PM.


© 2024 MH Sub I, LLC dba Internet Brands