turbo II swap guys, where did you get your thottle body elbow
My Jspec motor (91) came with the stock TMIC.
where can I get a forward facing elbow for the throttle body. |
Doesn't greddy make one for the T2 engine? I'd post this over in the 2nd gen section you might get better info there. I'm not sure there is anyone putting a T2 engine in a FB now a days, well if you can get a hold of Jim L he might know where to get one I guess.
I guess I'm licky because the 13B-RE has a pretty good stock TB elbow. |
I am not any help either. Iam using a Greddy Elbow, but it is for the 3rd Gen throttlebody, attached to the Cosmo engine/intake.
Check with the Australian guys. I believe they have an adapter, that takes your stock throttlebody elbow, and rotates it 180 degrees, so it faces forward. |
i did post it in the 2nd gen forum, they werent any help either.
They suggested using the NA elbow, or having one made. the Na elbow has a 4 in inlet or something huge like that. |
Could you cut off the stock inlet down to the flange then weld on a larger tube? Assuming you have access to a TIG or someone that does.
|
i can fab one up for you if you would , let me know!!
|
Try www.rxengineering.com under the speedshop, then miscellaneus.
They have an inlet that you can weld a mandrel bend onto to suit your I/C pipes. Or just weld on a short straight pipe and then use silicone hose to get the bends you need. |
on my comso , i juts cut the old one off, reshaped the angle and welded the old flange back on there, I doubt that helps you, but thats what I did
|
the Rx engineering one looks good
680, check your PMs |
All times are GMT -5. The time now is 04:41 PM. |
© 2024 MH Sub I, LLC dba Internet Brands