SK racing sidedraft carb and ported manifold pics
 

Here are a few pics of some parts I just picked up.

2

3

https://www.rx7club.com/forum/attach...postid=1760277
https://www.rx7club.com/forum/attach...postid=1760429
https://www.rx7club.com/forum/attach...postid=1760288
lookin good man, a little bit of cleanin and that will all look brand new :D

that looks exactly like my settup. Except for the carb, I have a 45DCOE weber.

You will need to bolt on the heat shield that's missing on the lower part of that sidedraft TWM style manifold or you will loose some power and maybe have vapor lock problems...

What jets are you running it that Mikuni???

I have the same lake cities manifold with my dellorto 48 sidedraft.

K&N makes an air filter that is 3 1/4" tall and is ~9.5"wide and ~6" wide. I use that and can fit 50mm TWM Induction Full radius air horns in there. Great setup.

I bet with that ITG air filter there's either no air horns or some cheapo 1" air horns.

Go TWM if you want max performance!

You can also take a stock factory exhaust heat shield, pop rivet 1/8" aluminum sheet inside it and bolt it onto the upper exhaust studs to make a real nice dual layer heat shield.

Later,