Racing Beat Power Pulse intake - too tall?
#1
Racing Beat Power Pulse intake - too tall?
I have a RB intake airbox and it seems like the air filter element I got for it (from Mazdatrix, specifically for this airbox) is tall enough that the airbox doesn't clear the hood. The through bolt also seems a little short. So it seems like the hardware kit anticipates a shorter element.
Should I be a little more aggressive with squishing it down? Or should I be looking at a smaller element?
Here's a photo (I know the carb mounting nuts are missing, this is just a test fit)
Should I be a little more aggressive with squishing it down? Or should I be looking at a smaller element?
Here's a photo (I know the carb mounting nuts are missing, this is just a test fit)
#3
Moderator
iTrader: (3)
^ Right.
Cpt. Gloval ~
It's been ages, but I used to crank mine down until it rested on the frame. It just seemed like the thing to do. I honestly can't remember if I ever tested to see if it would otherwise hit the hood so I don't know if there's a "problem" with yours. What I can say for certain is it cleared just fine the way I installed it.
Cpt. Gloval ~
It's been ages, but I used to crank mine down until it rested on the frame. It just seemed like the thing to do. I honestly can't remember if I ever tested to see if it would otherwise hit the hood so I don't know if there's a "problem" with yours. What I can say for certain is it cleared just fine the way I installed it.
Thread
Thread Starter
Forum
Replies
Last Post
zlyricist
1st Generation Specific (1979-1985)
2
06-22-06 05:59 PM