Racing Beat Power Pulse intake - too tall?
I have a RB intake airbox and it seems like the air filter element I got for it (from Mazdatrix, specifically for this airbox) is tall enough that the airbox doesn't clear the hood. The through bolt also seems a little short. So it seems like the hardware kit anticipates a shorter element.
Should I be a little more aggressive with squishing it down? Or should I be looking at a smaller element? Here's a photo (I know the carb mounting nuts are missing, this is just a test fit) https://cimg9.ibsrv.net/gimg/www.rx7...c285dd533a.jpg |
I think those foam ones have a steel mesh screen on the inside. Does it feel like you are squishing the screen? Or the foam only so far?
|
^ Right.
Cpt. Gloval ~ It's been ages, but I used to crank mine down until it rested on the frame. It just seemed like the thing to do. I honestly can't remember if I ever tested to see if it would otherwise hit the hood so I don't know if there's a "problem" with yours. What I can say for certain is it cleared just fine the way I installed it. |
shorten the ring where it sits on the carb.
|
Not squishing the mesh yet, wanted to err on the side of caution. Doesn't seem like a good idea to remove any ring where it seats on the carb since that's velocity stack and will be too big an opening with any material taken off.
|
Cranked it down another half turn. Clears the hood now. Tight clearance
|
All times are GMT -5. The time now is 10:57 AM. |
© 2024 MH Sub I, LLC dba Internet Brands