RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   1st Generation Specific (1979-1985) (https://www.rx7club.com/1st-generation-specific-1979-1985-18/)
-   -   Car not cranking (https://www.rx7club.com/1st-generation-specific-1979-1985-18/car-not-cranking-662988/)

justint5387 06-17-07 02:53 AM

Car not cranking
 
My car is not cranking, but the fuel pump is running. Is it likely to be the starter? I was going to go auto-x tomorrow too :(

justint5387 06-17-07 03:24 AM

Also, smoke start coming out from the left side of the engine... Since the starter is there, it should be the starter:Wconfused

Manntis 06-17-07 04:10 AM

it's not cranking? as in you don't hear it turning over at all? Or it cranks over, but doesn't start?

trochoid 06-17-07 08:27 AM

Smoking is usually a sign of battery cables getting hot and melting due to either too much electrical resistance or the starter/engine is locked up. Start with a fresh set of battery cables and see if that helps.

justint5387 06-17-07 02:20 PM


Originally Posted by Manntis (Post 7050381)
it's not cranking? as in you don't hear it turning over at all? Or it cranks over, but doesn't start?

The car is not cranking, you don't hear any turning over at all. This morning, I tried to start it, it would turn over a couple time and die again. I thought it might be the battery, but it still won't crank when i try to jump start it.

twinkletoes 06-17-07 06:49 PM

Starter, had the same problem. working fine one day. The next, no crank at all. New starter in, started up fast.

justint5387 06-18-07 01:19 AM


Originally Posted by twinkletoes (Post 7052023)
Starter, had the same problem. working fine one day. The next, no crank at all. New starter in, started up fast.

Thanks for your help.

mazdaverx713b 06-18-07 07:45 AM

as trochoid said, there's something not right and drawing too much resistance. either you have a bad battery cable or it doesnt have a good ground or the starter is seized from age or clutch dust buildup. or maybe the starter got too hot from cranking at some point and failed or just plain went bad. it happens. i would first check the cables and grounds. then i would check the connections at the starter. if nothing happens there, replace the starter. if still nothing, go through those cables again.


All times are GMT -5. The time now is 07:53 PM.


© 2024 MH Sub I, LLC dba Internet Brands