![]() |
backfires on command
If I rev my car up to about 4 grand and let off the gas, it will backfire every time. Is this causing any damage? Sould I expect some time to blow my exhaust off the car?
:D |
|
If you have a Racing Beat exhaust, the welds on those things can stand up to a direct nuclear attack. Fire away! :D
If you don't have a Racing Beat exhaust, wait till this one eventually explodes, then install one. Avoid the local constable while running with a blown apart exhaust, muffler baffles hanging on the ground and all. |
to avoid the backfiring, the purpose of the Air Control Valve is to reduce or cut out the backfiring. You may need to replace it...
|
My GSL-SE with a Rotary Engineering header and exhaust backfired for years. It turned out to be the Throttle position Sensor. I adjusted it and no backfires since.
https://www.rx7club.com/showthread.p...tps+adjustment This is the thread on how to adjust it. Very easy. Steve |
i'm running my 6 port street port with a holley setup, and before friday it would pop all the friggin time, give it too much gas, pop, decelerate, pop, change gears pop... then i hooked up trailing ignition, and i'll be damned if i can even get it to pop on deceleration... i had an issue where my pulley was put on 180 degrees off, so i was 180 out, so i could only run leading ignition(which i had to run L1 on the L2 plug and vice versa)... went out friday and fixed that and now i don't backfire :( but i have power all the way to redline lol
|
| All times are GMT -5. The time now is 03:29 AM. |
© 2026 MH Sub I, LLC dba Internet Brands