Finally got to the track...12.757 @ 111.18
#1
Full Member
Thread Starter
Finally got to the track...12.757 @ 111.18
Ok I finally made it to the track last night. I have not gone to the dragway in over 14 years. So I was a bit nervous. I actually hit the brakes before the 1/4 mile was over on the first run. I got to the track late so only ran twic. Oh and I forgot to let some air out of my M/T ET Streets. I ran them with 32psi so hoping next time aired down to 16psi I can cut a better 60' time.
First run:
R/T... .386
60'.....2.044
330....5.545
1/8.....8.399
MPH...86.39
1000..10.819
1/4.....12.918
MPH....106.53
Second run:
R/T.... .806
60'......2.076
330.....5.522
1/8......8.340
MPH.....87.68
1000....10.728
1/4.......12.757
MPH......111.18
Dynoed at 310hp. Running stock turbos, stock motor, Apexi Power FC, SMIC, ACT lightened flywheel, ACT clutch, 550/1300 injectors and Mickey Thompson ET Streets, down pipe, magnaflow mid and RacingBeat dual tip muffler.
First run:
R/T... .386
60'.....2.044
330....5.545
1/8.....8.399
MPH...86.39
1000..10.819
1/4.....12.918
MPH....106.53
Second run:
R/T.... .806
60'......2.076
330.....5.522
1/8......8.340
MPH.....87.68
1000....10.728
1/4.......12.757
MPH......111.18
Dynoed at 310hp. Running stock turbos, stock motor, Apexi Power FC, SMIC, ACT lightened flywheel, ACT clutch, 550/1300 injectors and Mickey Thompson ET Streets, down pipe, magnaflow mid and RacingBeat dual tip muffler.
#2
Senior Member
what boost u running?
#5
Full Member
Thread Starter
Sometime this week I plan to go back and run with 20psi in the ET Streets and launch around 5.5-6k rpms.
#6
Eats, Sleeps, Dreams Rotary
iTrader: (17)
first 2 runs were 13.2 and 13.0, then I adjusted tire pressures to 35psi front 18psi rear, side stepped the clutch at 6k rpm and shifted right at 8k rpm.
got a perfect no hop launch with a combination of tire and clutch slip that gave me the 2.00 60' and 12.8s et.
#7
Full Member
Thread Starter
Went again tonight to the dragway and got redemption. First few runs hit 13.3 @ 109 and 13.4 @ 111 because the track was kind of wet. Parked the car for an hour let other cars heat the track up by running and took my FD out for a last run and end up cutting a 1.8 60 foot 12.4 @ 110.
Trending Topics
#10
Full Member
Thread Starter
#12
Full Member
Thread Starter
I'll be back in April when the track reopens.
#13
Senior Member
iTrader: (9)
I only go to an 1/8 mile track.
60' --------- 1.7485
330' ------- 5.0880
1/8 ET ----- 7.8589
1/8 MPH --- 88.20
This was on a 370whp tune at 16psi I think... Every time I made more power it only ever made the results worse on street tires. They prep the track I go to pretty well too.
I expect to go back with the et streets, at about 450-475whp on pump gas, and am hoping for a 7.30, and i'd like a 6.99 on race gas, and somewhere north of 500whp. Just not sure how far north.
60' --------- 1.7485
330' ------- 5.0880
1/8 ET ----- 7.8589
1/8 MPH --- 88.20
This was on a 370whp tune at 16psi I think... Every time I made more power it only ever made the results worse on street tires. They prep the track I go to pretty well too.
I expect to go back with the et streets, at about 450-475whp on pump gas, and am hoping for a 7.30, and i'd like a 6.99 on race gas, and somewhere north of 500whp. Just not sure how far north.
#17
just dont care.
iTrader: (6)
for reference, i ran this on the stock turbos several years ago:
R/T -----.167
60' ----1.807
330 ---5.082
1/8 ----7.785
MPH ---92.06
1000 --10.114
1/4 ----12.091
MPH ---115.00
setup was stock turbos non-seq, stock intercooler, no exhaust (open downpipe), 14psi boost, apexi PowerFC, some high treadwear normal street tires, pretty fast shifts.
i hadnt dyno'd at that point, but it should have been ~330whp.
R/T -----.167
60' ----1.807
330 ---5.082
1/8 ----7.785
MPH ---92.06
1000 --10.114
1/4 ----12.091
MPH ---115.00
setup was stock turbos non-seq, stock intercooler, no exhaust (open downpipe), 14psi boost, apexi PowerFC, some high treadwear normal street tires, pretty fast shifts.
i hadnt dyno'd at that point, but it should have been ~330whp.
#18
Full Member
Thread Starter
#20
Full Member
for reference, i ran this on the stock turbos several years ago:
R/T -----.167
60' ----1.807
330 ---5.082
1/8 ----7.785
MPH ---92.06
1000 --10.114
1/4 ----12.091
MPH ---115.00
setup was stock turbos non-seq, stock intercooler, no exhaust (open downpipe), 14psi boost, apexi PowerFC, some high treadwear normal street tires, pretty fast shifts.
i hadnt dyno'd at that point, but it should have been ~330whp.
R/T -----.167
60' ----1.807
330 ---5.082
1/8 ----7.785
MPH ---92.06
1000 --10.114
1/4 ----12.091
MPH ---115.00
setup was stock turbos non-seq, stock intercooler, no exhaust (open downpipe), 14psi boost, apexi PowerFC, some high treadwear normal street tires, pretty fast shifts.
i hadnt dyno'd at that point, but it should have been ~330whp.
#21
Full Member
iTrader: (7)
What rpm are you guys launching at on street tires? I'm going to be on a 275/35 or 285/30. On stock tires I was launching at 3,500 and my best time was 2.2 60 ft and 13.7@107mph.
stock turbos @10psi
apexi PFC on base map
hks downpipe
custom 4in midpipe
apexi gt spec 4in axle back.
koni yellows with eibach pro kits set to soft. ( doubt hard/soft makes a difference on koni)
Any tips on how to improve the time? I really need to work on my 2-3 shift. And i feel like i should be at 13.5 but either my launch is bad or that 2-3 shift.
Also car was dynoed at 247rwhp with the stock midpipe.
stock turbos @10psi
apexi PFC on base map
hks downpipe
custom 4in midpipe
apexi gt spec 4in axle back.
koni yellows with eibach pro kits set to soft. ( doubt hard/soft makes a difference on koni)
Any tips on how to improve the time? I really need to work on my 2-3 shift. And i feel like i should be at 13.5 but either my launch is bad or that 2-3 shift.
Also car was dynoed at 247rwhp with the stock midpipe.
Last edited by Unkachabull; 03-11-15 at 02:58 PM.
#22
Eats, Sleeps, Dreams Rotary
iTrader: (17)
6-6500
Originally Posted by unkachabull
what rpm are you guys launching at on street tires? I'm going to be on a 275/35 or 285/30. On stock tires i was launching at 3,500 and my best time was 2.2 60 ft and 13.7@107mph.
Stock turbos @10psi
apexi pfc on base map
hks downpipe
custom 4in midpipe
apexi gt spec 4in axle back.
Koni yellows with eibach pro kits set to soft. ( doubt hard/soft makes a difference on koni)
any tips on how to improve the time? I really need to work on my 2-3 shift. And i feel like i should be at 13.5 but either my launch is bad or that 2-3 shift.
Also car was dynoed at 274rwhp with the stock midpipe.
Stock turbos @10psi
apexi pfc on base map
hks downpipe
custom 4in midpipe
apexi gt spec 4in axle back.
Koni yellows with eibach pro kits set to soft. ( doubt hard/soft makes a difference on koni)
any tips on how to improve the time? I really need to work on my 2-3 shift. And i feel like i should be at 13.5 but either my launch is bad or that 2-3 shift.
Also car was dynoed at 274rwhp with the stock midpipe.
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM