Post Pics of your FD Wheel Fitment!!
#2006
Make an assessment...
iTrader: (3)
Oh I'm going through with them as long as everything works out. If this doesn't happen, it won't be on my end haha. He is starting to do the CAD right now, I'm just shopping around for lips and barrels so he knows all the specs for the mounting flange. After that, I'll see if my coworker's buddy or someone else in C Springs or Denver can cut them, then get them coated, chromed or whatever, then on the car. I'm so stoked lol.
#2011
Make an assessment...
iTrader: (3)
Not without pulling the fenders a bit. The rear about an inch, and the front about half inch at least. Depends on tire fitment too though. If you stretch enough you MAY be able to pull it off.
Actually it looks like stickboie pulled it off. If I'm reading this correctly, the rears are 18x10.5 +7, and his tire looks to be stretched quite a bit. So you could probably make it work. I'm not sure how that's possible though because my RPF1 10.5 +15 stuck out about an inch from the stock fender. And 9.5 +22 on the front was pretty even with the fender.
Actually it looks like stickboie pulled it off. If I'm reading this correctly, the rears are 18x10.5 +7, and his tire looks to be stretched quite a bit. So you could probably make it work. I'm not sure how that's possible though because my RPF1 10.5 +15 stuck out about an inch from the stock fender. And 9.5 +22 on the front was pretty even with the fender.
#2022
Running a similar set up next year. All 18in tho. And 18x10 et38 front, with a 12mm spacer and 10mm spacer out back. also gonna run a 265 in the rear and the same 255 up front. Im at 0 degree camber all the way around but if you were to go -3 or -4 up front you can run all the same size with rims being 18x10.5 et15. But I'm not that guy. I hate that crap. Each there own i guess. Keep in mind that my rear quarter is flared about an inch to 1.5. The front is rolled not pulled.
front 18x10 et38 w/12mm spacer 255/35
rear 18x10.5 et15 w/10mm spacer 265/35 gonna be tight but i can remove the space if i wanna go lower so that it will clear the quarter if needed.
The following users liked this post:
SpeedCrazie (06-18-17)