Super AFC Throttle reads zero?
#1
Throttle reads zero?
All the sudden my S-AFC has no throttle input. But it still drives around? I guess it's just running things purely off of the AFM, but I'd like to have my throttle back. Anybody have any ideas? I've replaced and calibrated the TPS and that didn't solve it. The soulder's haven't busted either....
It's real annoying, and I think it's related to my problem with running rich all the time. I'm about to upgrade to megasquirt; but this is my DD and I'd like to get it running properly until I do.
Thanks for the help guys!
It's real annoying, and I think it's related to my problem with running rich all the time. I'm about to upgrade to megasquirt; but this is my DD and I'd like to get it running properly until I do.
Thanks for the help guys!
#2
Partout Performance
iTrader: (24)
Join Date: Mar 2007
Location: .
Posts: 1,202
Likes: 0
Received 0 Likes
on
0 Posts
Check your connection at the ECU. Both the terminal and the solder you made.
Also, I have found that on the SAFC1s the board on the inside of the module becomes unglued or unscrewed from the base and floats around and the wires start to come off. My rpm signal was lost do to this. The SAFC is only 4 screws and it will if anything prove that that ISN'T it.
Also, I have found that on the SAFC1s the board on the inside of the module becomes unglued or unscrewed from the base and floats around and the wires start to come off. My rpm signal was lost do to this. The SAFC is only 4 screws and it will if anything prove that that ISN'T it.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM