You are currently viewing our forum as a guest, which gives you limited access
to view most discussions and access our other features. By joining our community, at no cost, you will have access to start new topics, reply to conversations, privately message other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join RX7Club.com today!
Ok the 'manual' has old p/n's from what I can tell and have read. It says the first 3 digits of the p/n is supposed to be stamped on the casing of the sensor but all I see is 466 on the top of the case and 9756-B2 on the underside. The damn sticker on my sensor is faded out and i can only read partial numbers 0830...242
The connector on my wiring loom is orange which the manual states is for 2/3 bar units but I want to find out if I have the 2 or 3 bar unit.
Any help?
This ad is not displayed to registered or logged-in members. Register your free account today and become a member on RX7Club.com!
__________________
Quote:
Socialism is a philosophy of failure, the creed of ignorance, and the
gospel of envy. Its inherent virtue is the equal sharing of misery.
-- Winston Churchill
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
The 3-bar unit has a slot that is "horizontal" pointing to the other two pins.
You cannot tell the difference between the 1-bar and 2-bar unit though...
Linear Mode
