Special thanks to E&J autoworks/Balancing Whiz...
03-16-14, 08:21 PM
#30
Replace often ....
on a side note to update this thread... My ECU friedDue to my ignorance, I prolly had a bit too many (cervesa) because instead of charging battery I decided to "JUMP" the battery while haltech ECU "ONLINE" VERY BAD IDEA
So off to haltech USA it went... And now it's on it's way back home where she belongs.
Stay tuned again....
03-17-14, 03:12 AM
#31
Yes its slow
iTrader: (7)
Join Date: Jan 2002
Location: usa
Posts: 2,455
Likes: 0
Received 0 Likes
on
0 Posts
It was hit & miss.... If you plan to go better than a 1.5 60 ft..... Be prepared to
Replace often ....
on a side note to update this thread... My ECU friedDue to my ignorance, I prolly had a bit too many (cervesa) because instead of charging battery I decided to "JUMP" the battery while haltech ECU "ONLINE" VERY BAD IDEA
So off to haltech USA it went... And now it's on it's way back home where she belongs.
Stay tuned again....
04-02-14, 12:02 PM
#38
It worked great for a while!! I'm confident that with a fresh rebuild Mazda diff, it would hold no problem... I always had used diff's which resulted in not a fun ride at the big end due to worn diff's
After time... So I jus opted to go with a new diff
That's designed for racing... I ran a best time of 9.52 & best 60ft of a 1.33 with factory diff .. So yea it works!!
After time... So I jus opted to go with a new diff
That's designed for racing... I ran a best time of 9.52 & best 60ft of a 1.33 with factory diff .. So yea it works!!
05-03-14, 11:08 PM
#39
It worked great for a while!! I'm confident that with a fresh rebuild Mazda diff, it would hold no problem... I always had used diff's which resulted in not a fun ride at the big end due to worn diff's
After time... So I jus opted to go with a new diff
That's designed for racing... I ran a best time of 9.52 & best 60ft of a 1.33 with factory diff .. So yea it works!!
Make sure you check out ALL parts even if they were "new" parts installed ... Cuz let me tell you I was schooled
When I realized they are used as soon as you apply anything to it..... Bottom line my brand new oil control
Rings went through HELL before the balancing process and when I put everything back together i over looked
The obvious , cuz I figured they were "new" when installed less than 40 miles use... But when my front Bearing
Let go it took out the oil control rings... Learn from my mistake & always check everything ,,,, cuz it ill bite u in your
*** if over looked... With all his said she's built again & ready for boost very soon.... Stay tuned ....
Bout time....
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM
23Racer
Race Car Tech
1
09-21-15 10:48 AM
