BusaNostra

iTrader: (1)

I have a single turbo conversion (800-1600 injectors) project using PowerFC. The car will run if I put the stock ecu. If i put the powerFC, it will not run and no sparks. I sent it in Japan and came back. The tech said, they found nothing wrong on the unit. I put the stock ecu again and the car runs. I put the powerFC and no sparks.

So, I suspected that the tech did not do anything. I sent it to the other tuner in Japan (JapanDyno) the second time. They sent it to be repaired. They found nothing wrong again, I paid so much. The only thing they did was to load a new firmware. (that's what they told me).

Now, I'm ready to install it again but I'm not optimistic it will run. A friend gave me a map for 800-1600 injectors. Do you think I should load this map or try the basic map first. Do you think I have a basic map in my current powerfc after they load the firmware?

Thank you

cewrx7r1

iTrader: (2)

Do you know for sure that you have the correct PFC for your car?
Which you have not told us which model it is.

BusaNostra

iTrader: (1)

Yes I do... the 1st tech and Japan Dyno bothverified it that was the right PowerFC for my 1993.

I'm just looking for some feedback perhaps i'm missing something here. I will try to install it again and see if the new firmware as they claimed might makes the difference.

BusaNostra

iTrader: (1)

Is it possible I don't have the basic map?
Even resetting it...could it be no basic map?

cewrx7r1

iTrader: (2)

If your injectors are still stock (550-850), then you want to use the stock map in the PFC.
If you have already installed the (800-1600), then you have to properly setup the injectors on the map first.

You appears that you need a local PFC user with experience to help you.
Find one.


You still have not told us which car you have.

cewrx7r1

iTrader: (2)

Me bad.

BusaNostra

iTrader: (1)

i have 800-1600 cc already installed. I will find someone with the same size and borrow a map -- see if it will fire up.

BusaNostra

iTrader: (1)

oh...by the way, how can i load a map in my commander then to the powerfc? I can't read the .dat file. I have no software to read the .dat. Someone emailed me a map.

arghx

iTrader: (3)

You need to buy a Datalogit.

Jackson Richard

iTrader: (1)

how do you know you have n o spark what type of diag have you done other than just it does not start...

what sensors are shown and what voltages on your commander?

thewird

iTrader: (8)

Is there RPM on the commander when you crank the car?

thewird