rx4 trans problem
#1
life's a drag*)
Thread Starter
iTrader: (5)
Join Date: Jan 2012
Location: greenville,sc
Posts: 813
Likes: 0
Received 0 Likes
on
0 Posts
rx4 trans problem
OK so I need some info, I'm in the process of putting a 13b with a 225mm flywheel and clutch in a 74 rx4 with its factory 4 speed.
Now the problem is, it seems the pressure plate is hitting the bell housing.
I can turn the motor by hand then it hits and locks down, I can turn it back the other way and same thing.
So is it not possible to use a 225mm clutch with the factory 4 speed?
Now the problem is, it seems the pressure plate is hitting the bell housing.
I can turn the motor by hand then it hits and locks down, I can turn it back the other way and same thing.
So is it not possible to use a 225mm clutch with the factory 4 speed?
#3
life's a drag*)
Thread Starter
iTrader: (5)
Join Date: Jan 2012
Location: greenville,sc
Posts: 813
Likes: 0
Received 0 Likes
on
0 Posts
I'm using an act clutch and pressure plate. But the pursue plate is definitely hitting something in the bell housing, it will only let the engine turn half a rotation by hand. I'm going to pull it back out for the 3rd time now and see if I can find where it's hitting, I'll let you know what I see, this just sucks.
#4
life's a drag*)
Thread Starter
iTrader: (5)
Join Date: Jan 2012
Location: greenville,sc
Posts: 813
Likes: 0
Received 0 Likes
on
0 Posts
Fixed it. On the top of the bell housing right in front of the clutch fork on the inside. There's a little hump that I had to trim down with my angle grinder. Now it turns freely.
Thread
Thread Starter
Forum
Replies
Last Post