New mem writing in tech sct. auto/manual conversion 1990 rx7 transmission mount probl
#1
Junior Member
Thread Starter
Join Date: Mar 2015
Location: FL
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
New mem writing in tech sct. auto/manual conversion 1990 rx7 transmission mount probl
Hello guys my name is Josh recently i been doing myself a automatic to manual transmission conversion to a 1990 Mazda rx7 I'm almost done but haven't finish because I don't know what to do. Becuase, my transmission mount is like 4 inches away from the chassis not exactly sure if its 4 inches just an estimate so the transmission mounts are closer to the engine than were its suppose to be. I saw a forum on how to do the whole conversion but I don't understand how to do the custom transmission mounts i need to see it visually to understand or just clearer instruction for me. I will really appreciate if I get pictures of some done and I'll apriciate the help and the replies thanks in advance
#2
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
Well, you have two choices.
You can cut and weld the transmission mount so it lines up.
Or you can drill the spot welds out of the mounts on the car, move them forward, and re-weld.
You can cut and weld the transmission mount so it lines up.
Or you can drill the spot welds out of the mounts on the car, move them forward, and re-weld.
#3
Junior Member
Thread Starter
Join Date: Mar 2015
Location: FL
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Thanks sounds good but with all respect isn't their a way to do like a cross member or custom mnts. That you know its that I don't have a good welding machine.
Thread
Thread Starter
Forum
Replies
Last Post
KAL797
Test Area 51
0
08-11-15 03:47 PM