lim_fc3c

iTrader: (4)

Pretty much everything wanted in a n/a build with a broad power curve is on this car.
85 gsl-se
S5 6 port 13b
Angelmotorsports "race" port with bridged primaries
Tii center plate and tii s5 housings.
RA classic apex seals and solid corner.
Race head 48mm itb's with Bosch bmw tps
Racing beat side draft upper
Racing beat dual "street port" system
Exedy hyper single stage 3 clutch
S4 tii trans
Kia 4.77 gearset with s4 gxl posi unit
Microsquirt ecu
4x ls d585 truck coils (direct fire)
Two id1000cc injectors
T3 weld on coilovers with koni yellows front
Mustang upr coilover with strange 10way shocks rear
Enkei 92's
Currently installing new ecu setup, upgrading from a old haltech f7b fuel only with msd 6al-2.
Raced a gsr swapped civic 170whp on motor with a 75shot and drag radials.
Dig race: no contest rx7 wins by 5+ cars
Roll race: 40mph neck and neck until 4th and 5th (4.77 lol) pulled 2 car lengths.
Guessing from this I had to be extremely close to breaking 200whp or more.
Enough chatting. Picture time.
















5th-reverse lockout

Murilli

iTrader: (1)

Nice build! Very curious as to what power it's making. I have a very similar build, and soon to be going MS3. Kinda wish i had a 1st gen now though. Anyways, looking forward to hearing more.

diabolical1

iTrader: (3)

this looks like great stuff. i really dig it! i don't get what the rigged shifter is all about, but everything else i understand fully. kudos!

the S4 unit bolts right in? if so, i never knew that.

lim_fc3c

iTrader: (4)

Shifter base is a 5th-reverse lockout, so no miss shifts into 5th or in between. Works good on tracks or rough driving conditions. Yes from what I hear n/a fc's miata's and s2000's differental units are the same. All use a 7" style ring gear. Not saying the ring and pinions will swap just the units.