Engine builder
#1
Junior Member
Thread Starter
Join Date: Nov 2010
Location: Farmington, nm
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Engine builder
Hello all! I'm in search of someone who rebuilds rotaries. Azrr was supposed to build my motor but after a year of him having my car the only thing he did was tear the motor apart. I got fed up on his crap and picked up my car and now the rx just sits in my garage, so if anybody knows of any good builder in as or nm it would be most appreciated! Thanks!
#2
Full Member
iTrader: (7)
Andy Barrow at RaceFab. He's located in the 500 block of Wyoming SE in Albuquerque. He's built two of my motors and can do ports as well. He's a bit cheaper if you take the motor to him but he will do the entire thing if you don't want to mess with removal and install. He just had someone literally drive into his shop so he may not be doing anything for a few weeks.
#3
Junior Member
Thread Starter
Join Date: Nov 2010
Location: Farmington, nm
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the reply!! I'm gonna give them a call and see wat they can do. Do they tune rotaries as well? I know tuning rotary engines is something of a special skill from wat I've been told. There's a shop here called stett performance but he has never built a rotary before but he said he has tuned them at his shop in Dallas but I'm a little skeptical about it. Last thing I want is too blow up my motor again!
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
KAL797
Test Area 51
0
08-11-15 03:47 PM