Microtech Software problema
06-29-15, 08:43 PM
#1
Junior Member
Thread Starter
Join Date: Sep 2008
Location: El Salvador
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Software problema
Hi I have this proble in the microtech software wen I going to modify the parameter I try to modification put in 0 and I can't modify
07-01-15, 09:27 AM
#2
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
Is your ECU locked from your tuner?
If not, you could try switching it to matrix mode and making your change there.
Oh, I've seen versions of the laptop software where the keys are reversed. As in, down is up and up is down. Try the other key.
If not, you could try switching it to matrix mode and making your change there.
Oh, I've seen versions of the laptop software where the keys are reversed. As in, down is up and up is down. Try the other key.
07-01-15, 10:39 AM
#3
Junior Member
Thread Starter
Join Date: Sep 2008
Location: El Salvador
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
hi thanks for your response , as when the ECU is locked ?
and I test with several keys and all the same, when I positioned in the box I want change and pressed the M since then the parameter is set to " 0 " and since I can not change it does not move from 0
and I test with several keys and all the same, when I positioned in the box I want change and pressed the M since then the parameter is set to " 0 " and since I can not change it does not move from 0
Thread
Thread Starter
Forum
Replies
Last Post