Microtech Newbie software questions
#1
Newbie software questions
I've got an lt10c I inherited with a parts car that I bought recently.
The parts car was an 87 TII with an S5 engine. Mine is an 88 TII with an S4 engine.
I swapped pretty much everything ignition related over.. coils, uim, throttle body, lt10c.
The parts car started and ran fine.
I'm having a hard time getting mine started. It'll start with starter fluid, but not on its' own.
I was told that I should check the water and crank maps on the microtech software. I tried that last night, but was unable to get to the screens to adjust the maps.
According to the manual, the func/adj buttons should allow me to scroll through the screens but they dont seem to be working.
I put the ignition in the on position, F1 to connect the software to the microtech, then attempt to use the func/adj buttons with no success.
What am I missing? I know it's something simple.
The parts car was an 87 TII with an S5 engine. Mine is an 88 TII with an S4 engine.
I swapped pretty much everything ignition related over.. coils, uim, throttle body, lt10c.
The parts car started and ran fine.
I'm having a hard time getting mine started. It'll start with starter fluid, but not on its' own.
I was told that I should check the water and crank maps on the microtech software. I tried that last night, but was unable to get to the screens to adjust the maps.
According to the manual, the func/adj buttons should allow me to scroll through the screens but they dont seem to be working.
I put the ignition in the on position, F1 to connect the software to the microtech, then attempt to use the func/adj buttons with no success.
What am I missing? I know it's something simple.
Thread
Thread Starter
Forum
Replies
Last Post
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM