Haltech Tried searching but didnt help. I need my wipers to work!
#2
Senior Member
Join Date: Feb 2001
Location: Moncks Corner, SC
Posts: 409
Likes: 0
Received 0 Likes
on
0 Posts
do you have your original engine wireing harness still? if so cut the loom off and trace from the wiper connector to the main connector. Then just pop out all the pins except the ones for the wiper. Then just plug it in and your good to go.
if not, you need to get the factory service manual wiring diagrams and create a cable to go from the wiper motor to either the switch or the harness attached to the inside of the pass. side kick panel
if not, you need to get the factory service manual wiring diagrams and create a cable to go from the wiper motor to either the switch or the harness attached to the inside of the pass. side kick panel
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM