Haltech setting ignition map
#1
rx7 killer
Thread Starter
setting ignition map
sorry if this has been a repost but i cant seem to figure out the ignition map?? can any one explain the set up...?? ive had it down to where the injectors are coming on but im not getting spark.....its a 13b re stock twins and injectors just a front mount....just a clarification on how the map is set up....
#4
EFI Tech Wannabe
iTrader: (1)
Join Date: Sep 2003
Location: D.R., USA, the world...
Posts: 2,405
Likes: 0
Received 4 Likes
on
4 Posts
Just download one of the base maps in the base map thread and compare them, im sure you'll see what's happening, and you should also try finding out about rotary ignition systems and how they work. I recommend you download one that suits your engine combination, maybe a stock 13BT with 550/850 combo, or a REW stock map and change the ignition setup to suit 2nd gens.
Try this link.
http://www.teamfc3s.org/info/articles/demystifying.html
Try this link.
http://www.teamfc3s.org/info/articles/demystifying.html
#5
rx7 killer
Thread Starter
so a couple questions.....
as for one there are 3 fires in one rotor revolution?? so how is it to control both trailing and leading?? setting them 15deg apart from the time they have already fired??
also on the ignition map,at the top there are negative numbers counting up by increments ex. -706 -660 -600 -590.....up to 4 or whatever...what am i seeing??
also when setting ignition, our main refrence is the eccentric shaft or the rotor??
since each have a a diffrent turning ratio to each other will it make a diffrence???
as for one there are 3 fires in one rotor revolution?? so how is it to control both trailing and leading?? setting them 15deg apart from the time they have already fired??
also on the ignition map,at the top there are negative numbers counting up by increments ex. -706 -660 -600 -590.....up to 4 or whatever...what am i seeing??
also when setting ignition, our main refrence is the eccentric shaft or the rotor??
since each have a a diffrent turning ratio to each other will it make a diffrence???
#6
Lives on the Forum
I would recommend you first read the Haltech manual.
It's available for download from http://www.haltech.com/
Most of your questions will be answered in there.
-Ted
It's available for download from http://www.haltech.com/
Most of your questions will be answered in there.
-Ted
Thread
Thread Starter
Forum
Replies
Last Post
befarrer
Microtech
3
08-22-15 05:52 PM