Haltech need help with e6k setup.
#1
Full Member
Thread Starter
Join Date: Jun 2006
Location: hawaii
Posts: 229
Likes: 0
Received 0 Likes
on
0 Posts
need help with e6k setup.
i am using a dell labtop with windows xp. i downloaded the windows dosbox win32 installer. i downloaded the d-fend v2. i opened dosbox and mounted my haltech program. it opened but wont connect. i change the serial 1 to directserial realport:com9 and it tries to connect but a screen pops up on the haltech screen and it says that i need a later version software for haltech.
also in the dosbox status window.. it says the following when i open the e6k program.
warning: file creation failed: c:/games/e6k/e6kv634/LPT1
what does that mean and what is LPT1? isnt that a port? i dont have anything else plugged into the computer.
also in the dosbox status window.. it says the following when i open the e6k program.
warning: file creation failed: c:/games/e6k/e6kv634/LPT1
what does that mean and what is LPT1? isnt that a port? i dont have anything else plugged into the computer.
#3
Senior Member
iTrader: (5)
Join Date: Feb 2004
Location: nj & st.croix
Posts: 495
Likes: 0
Received 0 Likes
on
0 Posts
E6k Connection
I had to same problem ... So i went on WWW.TWEAKIT.NET download bootable file that works with windows .....an it works perfect....after you down load you gotta extract file an save it to floppy .... then load floppy into laptop then turn it on while floppy is in an it should start up in dos.....then click connect ...done...
You gonna see information on page...rite below its gonna say downloads ...bottom left of page....look for bootable with windows ...
You gonna see information on page...rite below its gonna say downloads ...bottom left of page....look for bootable with windows ...
Thread
Thread Starter
Forum
Replies
Last Post
joel(PA)
Race Car Tech
0
10-01-15 10:25 AM