hkp

iTrader: (2)

hey whats up, i am new to the forum but not to rx7's, i've owned like 5 s4's but this is my first tII. i bought the car from an old friend and he installed a haltech on it. he used it as his daily and stopped because it would just die on him and he didnt like it. he later determined that there was not enough fuel and blamed it on a faulty pump. this is where i come in, the car sat for a couple of years and i bought today. the uim was removed and there was random pieces laying around the engine bay, injectors not plugged in, vacumn lines everywhere and wires at random. what i want to know is, what can i just toss, i can see by the wires that were just cut and left behind that they probabley dont need to be there and vacumn lines that were cut and screws stuck in the end of so they can probabley go. i just dont know what is necessary to make the car run, i dont care about emisions, i am planning on keeping a/c and power steering, so what can i toss. i was thinking of buying one of those block off plate kits from the f.s. section. any advice would be greatly appreciated, thanks for the help.

hkp

iTrader: (2)

http://www.rotaryresurrection.com/te...s_removal.html
i think i am going to start with this and then do the banjo bolt mod, if that is bad pls let me know. also,
on the emisions removal, any thing else i can toss please let me know.

Claudio RX-7

iTrader: (1)

Bad link, check it.

hkp

iTrader: (2)

http://www.rotaryresurrection.com/te...s_removal.html
try this one. if it doesnt work, it is just the emisions removal from the tech sec. of rotary resurection.