BMonkey

I found a one piece 13B billet eccentric shaft on Rotor Master's website and I've never heard of this group. Have any of you dealt with them? If you have, was the quality of the parts good, exceptional,etc?

I'm not about to drop $1400AU +shipping back to the US unless I can find out some info on the shop.

Cheers,
Matt

REVERE

Never dealt with them personally but they are heavily into the drag scene over here and highly regarded as one of the best.

DMRH

I live only 30 minutes away from RotorMaster & have used them for dyno testing my Cosmo.

A mate just purchased a billet shaft from them yesterday as he is sourcing the required parts to put together another 13B-REW engine for his RX-7 (series-7)

I have 2 other rotorhead mates that have had their 20B engine rebuilt for their Cosmo's & spent near AU$10k with them each time. Neither guy has complained

They purchased the old K&N drag car from Abel Ibarra a couple of years ago so there would have been an eliment of trust with that deal.

REgards

dragFD

if your unsure about them they have a website i think where you can get more info they have another buisness called gas motorsport.i ve been to their workshop this year and dont see any problems with them.very profesional buisness.joe signorelli is a very well known bloke in the drag racing scene and is currently racing the 6 sec 2jz powered gas celica drag car(ex titan motorsports celica).dont worry he wont rip you off.