AEM sequential spark setting?
#6
~17 MPG
iTrader: (2)
The original 30-1800 startup calibration settings mimic the stock ECU by firing the leading coils twice per engine rev… once for the front rotor (Coil1 output) and once for the rear rotor (think of the Coil6 settings as being ‘Coil1B’, the second time the Coil1 output fires due to wasted spark).
https://borgtechnology.files.wordpre...m-ignition.gif
When changing to a sequential coil setup, wire the Coil1 output to the front leading coil, add a new wire from the Coil4 pin to the rear leading coil, and configure the settings as shown. You can find the Ignition Phasing options by selecting Ignition>>Advanced Ignition>>Ignition Phasing. Your software version may not have a menu with a checkbox for each coil, go to Options>>Coil and select or de-select the ‘Active’ checkbox for each coil.
https://borgtechnology.files.wordpre...q-ignition.gif
Hope that helps,
-s-
https://borgtechnology.files.wordpre...m-ignition.gif
When changing to a sequential coil setup, wire the Coil1 output to the front leading coil, add a new wire from the Coil4 pin to the rear leading coil, and configure the settings as shown. You can find the Ignition Phasing options by selecting Ignition>>Advanced Ignition>>Ignition Phasing. Your software version may not have a menu with a checkbox for each coil, go to Options>>Coil and select or de-select the ‘Active’ checkbox for each coil.
https://borgtechnology.files.wordpre...q-ignition.gif
Hope that helps,
-s-
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM