trouble getting the FD started..
#1
Full Member
Thread Starter
Join Date: Dec 2006
Location: gainesville,GA
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
trouble getting the FD started..
ok so n my recetntly purchased FD ive been noticing that on a cold start it takes a lil while to actually crank over and start.....just was wondering if this was a normal thig.......it doesnt just start up like any normal car..lol
#2
Rotor Mech. Need'd 4 Mods
iTrader: (3)
mine tends to do it, thats just b/c i dont start it up everyday, it sits in my driveway, =) until im done w/ it, but if its not ur daily driver go outside and start it every once in a while, keep it fresh, the battery might be going dead as well, keep that in mind.. but when it does turn over, yea, it usually takes a while to kick, its not a problem.. just tempormental issues, its ur FD hating u b/c u dont drive it.. =)
#3
Full Member
Thread Starter
Join Date: Dec 2006
Location: gainesville,GA
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
thats the thing i do drive it everyday...it used to be my daily driver...and now everyonce in awhile it will take a little longer then normal.....then have a little backfire sound....but only sometimes it does that?
#4
Rotor Mech. Need'd 4 Mods
iTrader: (3)
oh i see.. hhmm... well, i know some symptoms of rebuilds, but, b4 u worry about a rebuild, get some other opinions, but, 3-5 turnovers to start engine, white smoke after about 10 minutes of warm-up time.. and also if ur car has around 40 - 60k miles on it.. =/
Last edited by TT_Rotary; 05-20-07 at 06:34 PM.
Thread
Thread Starter
Forum
Replies
Last Post
FC3S Timmy
2nd Generation Specific (1986-1992)
16
10-03-15 01:08 AM
Red-Dragon_Akuma
New Member RX-7 Technical
11
09-28-15 06:09 AM