05-07-12, 12:47 PM
|
#1
|
|
r074r'/ |\|00B
Join Date: Jan 2002
Location: KC, KS
Posts: 799
|
Picture request - driver side wiring harness
A couple months ago I removed the wiring harness on the driver side to clean it up. It had a few wires with torn shielding and was caked with crud. I also managed to break a few connectors in the process. I'm talking about the harness that connects the negative ground to the battery, alternator, ignition, oil press, starter, etc.)
Regardless, I am ready to re-wrap everything and re-install it.
My only problem is my wife erased the memory card in my camera yesterday and I can't remember how everything was secured to the body/engine. I remember that the ground cable connected somewhere along the body and then closely afterwords everything took a 90* bend behind the power steering pump. It looks like it should then take another 90* bend downwards next to the block, and then finish at the starter. I'm sure I can make something work, I'd just prefer to have it redone as close to it should be for future troubleshooting.
Would anyone be able to take pictures of this wire-routing for me? I'd greatly appreciate it!
|
|
|
|
|
|
Linear Mode
