need advice on fuel problem

NCMontegott · 02-14-07, 05:03 PM

I recently completed repacing my vac lines, wiring harness, iat and fuelthermosenser.

Well after I put it all back toghether it is missing really bad the rpm are staying at around 700. but after warm up it will do mabye 500 then soon after it will stall.
I have replaced the plugs and ohm'd the plug wires, the are all in spec.

I have re re checked all of the vac lines and plugs for the wiring harness. I did replace the o rings for the injectors but did not have them cleaned. does anybody think this might be the problem? oh i did the egr solenoid trick no other codes stored in the cpu.

thanks in advance

Adam G

ArtsRx7 · 04-05-07, 10:13 PM

BUMP
I am having the same problems. I have just finished doing the same thing. I have searched the forum for countless hours and haven't found any answers. My car has the same symptoms as listed above and misses really bad yet uniform throughout the rpm range. Any suggestions would be greatly appreciated.

ArtsRx7 · 04-06-07, 10:14 PM

; /

VegasFD · 04-06-07, 10:45 PM

Did you try PMing the OP to see what fixed his issue?