Leaky secondaries? - fuel dripping from dp/mp connection
03-04-04, 12:13 PM
#1
BNR built motor and twins
Thread Starter
Join Date: May 2003
Location: 2 hours drive from sanity
Posts: 1,235
Likes: 0
Received 1 Like
on
1 Post
Leaky secondaries? - fuel dripping from dp/mp connection
Ok, my car ran fine yesterday with my upgraded fuel pump and 850 secondaries. I pulled the 850's and installed 1300's this morning. Now I have 550's and 1300's but the car will not start anymore (flooded) and fuel is dripping from the dp/mp connection after attemps to start the car. I'm guessing this is not a good thing... The 1300's were new ones from SR motorsports. Is there a fix for this or am I SOL???
I do not smell fuel around the injectors but I think one is just dripping into the LIM. I have new plugs that I will install in the morning and go from there. Is there anything else I can do? The injectors are seated good and no fuel or fuel smell around the inside of the rail.
I do not smell fuel around the injectors but I think one is just dripping into the LIM. I have new plugs that I will install in the morning and go from there. Is there anything else I can do? The injectors are seated good and no fuel or fuel smell around the inside of the rail.
03-04-04, 12:34 PM
#3
Full Member
Join Date: Jul 2003
Location: Malta
Posts: 167
Likes: 0
Received 0 Likes
on
0 Posts
i had the same problems when i done a fuel pump and fuel regulator install. i had fuel come out of the exaust manifold, i just installed new plugs and it started straight away. but not shoure about injectors good luck any way.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
