Koyo Fitment ???
#1
Banned. I got OWNED!!!
Thread Starter
Koyo Fitment ???
Im installing my Koyo and have a PFS IC...adn the duct wont fit through the opening of the frame and the top of the radiator even with the brackets reversed. The only other thing i see i can do to lower the koyo is to remove those bushing with bolts holding the top of the brackets on. Has anyone done this? Will the vibration be that bad if i take them off?
#2
Eats, Sleeps, Dreams Rotary
I had the Koyo....you could remove the bushings and put thinner rubber washers in to dampen the vibration...BUT I think you will hit the AC condensor. Mine was already almost touching the AC condensor WITH the bushings in place.
#3
Rotary Freak
Join Date: Dec 2002
Location: Slovenia, Europe
Posts: 2,522
Likes: 0
Received 0 Likes
on
0 Posts
I had to cut the duct a bit. Installed PFS IC previous weekend. Its a tight fit and you need to work it down a bit, but in the end it fits. The duct doesnt mate to IC as good as one would want, but I used some duct tape atm, until I decide what to do to fill that gap (about 2/3 of an inch at the top of the IC). But I love the IC, I just cant believe how cold the "cold side" of the IC is after some hard driving. It surely does it job well.
Good luck !
Good luck !
#6
Yes it is for sale.
Join Date: Aug 2002
Location: The Houston Club's Resident Lush.
Posts: 1,905
Likes: 0
Received 1 Like
on
1 Post
Its a form of Duct tape. Its used on heating duct vents and anywhere else that heat is a problem. It is aa piece of roled aluminium that has an adhesive backing to it. The stuff works great.
Thread
Thread Starter
Forum
Replies
Last Post
renjiv2
3rd Generation Specific (1993-2002)
57
01-25-24 03:34 AM
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM