donny

I am still getting a "flushing" noise through my firewall ( passenger side ) when I start the car and sometimes when I just rev the motor at a stop. I am thinking there must be air trapped in the coolant lines that the AST is not removing..
Any other thoughts??
Coolant level appears to be full..

spurvo

Are you checking the coolant level at the filler neck, NOT the overflow tank? The level should be low at the filler neck if you have air in the system, and it doesn't take much air at all to sound like a waterfall in the pass compartment (that's air moving through your heater core, BTW)

donny

Thats what I figured because the other day my water temp started to go sky high. I think it must have had an air lock.
How do I get the air out..???

David Beale

As stated elsewhere, you "burp" it out. Squeeze the rad. hose with the filler cap off. You should see some bubbles come out. Fill it to within 1-2" of the top. Run the car. When it cools off, do it again. It usually takes two to three tries to get it all out.

mmonaco

easier way, just keep squeezing the top and lower rad hose and keep filling it with water till it wont take anymore! Than start er up

Cihuuy

u can also fill it from the Throttle Body (tb) lines as it is the highest point. another thing you can do is to change to a 1.3 pressure radiator cap if you havent.

jpandes

DO THIS:

1. Open the filler cap

2. Remove the coolant line at the back of the Trottle body

3. Pour in coolant while squeezing the rad. hose to force air bubbles out of the system and out the tb coolant hose.

>>With the Tb coolant line off, all air bubbles should rise to this point since it will then be the highest point in the system.

4. Start the car, warm it up for five minutes with the heater on full (to get bubbles out of the heater core)

The repeat steps 1 through 3

Your're done.

SWAT81

iTrader: (14)

would the air bubbles eventually be gone if you dont do this step? I hear it all the time now when I start my engine and highway driving. Also, sometimes I get the coolant refill light come on me, so I have to refill like a half a cup full. Obviously, I have a small leak somewhere? I'm confused. Oh and I did squeeze the top and bottom radiator hose while filling in to get rid of air bubbles.

spurvo

If you are getting persistant coolant loss and air in the system, even though you are contantly adding coolant to the filler neck, do the champaign bubble test. You may be in for a nasty surprise...

pomanferrari

iTrader: (1)

Yeah, I second that. Start saving your money for a reman. I chased that air in coolant for a month then the terminal coolant buzzer went off. I was SOL by then.

EpitrochoidMan

I'm curious to find out if there is any link between o-ring failure and the use of higher pressure caps. Has anyone ever heard anything about this.