Greddy Profec EO-1 Question
#1
Banned. I got OWNED!!!
Thread Starter
Greddy Profec EO-1 Question
Finally found time yesterday to install my new Profec EO-1 boost controller. Turned the baby on and all I am getting are negative values for the boost. What have I got hooked up wrong? Any ideas? Did a search already but did not see anyone else with this anomaly. Probably just something dumb but could use a suggestion or two.
#2
Full Member
Join Date: Apr 2002
Location: raleigh, nc
Posts: 176
Likes: 0
Received 0 Likes
on
0 Posts
Interesting, I have not had any problems like that with mine. Try going through the settings menus and see if you have a perimeter set up wrong. Other than that, check to make sure your electrical connections and boost connections are straight. I would especially check the boost control selenoid as it is tricky to hook up correctly. good luck-B
#4
Banned. I got OWNED!!!
Thread Starter
Nevermind! The controller is working fine. I just did not understand the readouts and was confused at first. Thanks for the replies though. By the way, Sandfordman did you have any trouble getting the system to learn the LO boost auto settings? I have made a couple of runs and it has not locked-in the settings. The HI boost settings locked-in during the first two runs.
Thread
Thread Starter
Forum
Replies
Last Post
msilvia
3rd Generation Specific (1993-2002)
15
09-11-15 12:13 PM