FD3S Rev counter stopped working
10-31-14, 05:24 AM
#1
Junior Member
Thread Starter
FD3S Rev counter stopped working
Does anybody know if the FD3S are subject to rev counter failures?
I literally watched mine fluctuate up and down for a little bit, then cease working in front of my eyes, Rev buzzer and engine seem fine and runs without a problem which points to the cluster itself.
Is this a known problem and if so is there a quick fix, such as connector problem, bad earth etc.
I am running a PFC which was fitted prior to me purchasing the car from Japan.
Many thanks for taking the time to read my query.
I literally watched mine fluctuate up and down for a little bit, then cease working in front of my eyes, Rev buzzer and engine seem fine and runs without a problem which points to the cluster itself.
Is this a known problem and if so is there a quick fix, such as connector problem, bad earth etc.
I am running a PFC which was fitted prior to me purchasing the car from Japan.
Many thanks for taking the time to read my query.
11-02-14, 02:10 PM
#3
Full Member
iTrader: (1)
Join Date: Dec 2007
Location: islamabad, pakistan
Posts: 158
Likes: 0
Received 0 Likes
on
0 Posts
I had the same issue, its a pretty straight forward fix. Disassemble the tach, there will be a roundish
motor sort of thing behind the needle/face, just have all of the points on its circuit board resoldered.
That did it for me.
motor sort of thing behind the needle/face, just have all of the points on its circuit board resoldered.
That did it for me.
Thread
Thread Starter
Forum
Replies
Last Post
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM
Turblown
Vendor Classifieds
0
08-18-15 10:01 PM