Red-Rx7

Could someone please measure the double DIN in an FD3S 3rd gen?

I am wanting to know the width and height. If someone wouldn't mind running out to their car real quick and doing so... that would be great!

Exact measurements perferred.

mad_7tist

an exact measurementwould require removing the center piece because the trim covers some of it. what are you planning?

adam c

iTrader: (2)

7 3/8 X 4 3/4

Red-Rx7

hmmm..

this makes me wonder now. Ideas are welcome.

Trying to fit this in there:

http://logisysus.com/catalog/product...roducts_id=131

Its demensions are:
7.75W x 4.75H x 1.38D

It looks a little wider than what Adam had measured. But, I am not sure if this includes the trim piece or not? It would have to have some custom molding around it.

But, here is my delima.. Where do I put my receiver now? If the unit sits there, I have to place the receiver some where near that area...

Ideas welcome.

Red-Rx7

The only thing I can think of.. the divider between the cargo bins and the trunk area.. The black divider that pops out.. I was planning on mounting this (flush) to that: [img]http://www.anime.net/~gigagon/removable/c134.jpg[img]

Maybe I could mount the receiver under it? And get one with a remote? Then adjust volume that way? Ideas?

Hmm.

adam c

iTrader: (2)

PM str8down

I think he did something like this recently. He has some pics, and may have some suggestions.

Red-Rx7

Yeah. I was looking at his setup, but he uses a double-din all-in-1 combination unit. Therefore he doesn't have the problem with the receiver. It just folds away.

I think that is what I am going to do. On the back divider, I will put both CPU & receiver there.

Anyone have a picture of the back divider square on? I have been searching, and haven't found one yet.