??? on boost creep test......
#1
Got Rotors?
Thread Starter
iTrader: (1)
Join Date: Aug 2004
Location: Des Moines, Iowa
Posts: 580
Likes: 0
Received 0 Likes
on
0 Posts
??? on boost creep test......
I was curious if this test would work to see if i would get boost creep. I already ported my wastegate, but i just wanted to test and make sure it doesn't creep up there.
If i put the line for the wastegate to the turbine housing back to stock but take out the pill, it should boost 7 psi correct? Now if that's the case, it shouldn't creep up much if at all or am i wrong?
My EBC took a crap on me so i'm planning on doing a manual boost controller setup but i thought i might check out some things to make sure they work correctly before trying to dial in my boost. Thanks in advance....
If i put the line for the wastegate to the turbine housing back to stock but take out the pill, it should boost 7 psi correct? Now if that's the case, it shouldn't creep up much if at all or am i wrong?
My EBC took a crap on me so i'm planning on doing a manual boost controller setup but i thought i might check out some things to make sure they work correctly before trying to dial in my boost. Thanks in advance....
#4
Got Rotors?
Thread Starter
iTrader: (1)
Join Date: Aug 2004
Location: Des Moines, Iowa
Posts: 580
Likes: 0
Received 0 Likes
on
0 Posts
I actually forgot to add, this would work while leaving the extra nipple on the wastegate capped correct? I'm thinking yes, but i want to make sure i'm right before throwing it all back together.
Thread
Thread Starter
Forum
Replies
Last Post
Shainiac
Single Turbo RX-7's
12
07-17-19 02:20 PM
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM