T FC3 H

iTrader: (5)

Ive got the blitz sbc and power meter installed and everything is lighting up find and shutting off correctly. However, im having issues with the speed calibration on the power meter.

when i first installed this meter, it was calibrated for another car so it was able to read an estimated power output (so i know the wires were connected correctly). i decided that it wasnt accurate for my car since it wasnt calibrated for my car so i reset the power meter and here i am now with a dilemma.

I am aware that i am suppose to keep a steady 25 mph and then press the ENTER button. But, when i try to keep on 25 mph and then hit the button, i get a beep and message "Calibration Error!" What am i doing wrong? am i suppose to hit the cruise control on at 25mph to keep it steady?

anyone have this meter and would like to offer some advice. anything would help. thanks.

DaleClark

iTrader: (55)

I followed the instructions in the manual to calibrate, worked just fine. Make sure you're tapped into the speed sensor signal.

If this is on an FC, the speed signal comes from the cruise control computer, BTW, not the ECU.

Dale

T FC3 H

iTrader: (5)

i actually did tap it into the speed signal from the cruise control. my question is that do i have to use cruise control to keep it at a steady 25 mph then press enter? or can i just feather it with my foot and press enter?